» Seeger support washers
» Seeger shim washers
Material:
Shim washers: steel St 2 K 60 (strength 600-750 N/mm²)
Support washers: spring steel HRC 44-49.
Finish:
From 2 mm thickness upwards, side faces are ground. Single thickness deviations are within the thickness tolerance.
Surface:
To manufacturer's choice
Shim washers:
- Self-finish and oiled
Support washers:
- Self-finish and oiled
- phosphated and oiled
Please note:
The thickness values specified in the data charts apply to the self-finish and phosphated washer versions. If special versions of washers with different surface coatings are supplied, these dimensions will be increased by the corresponding coating thickness.
Important:
The thickness tolerances of washers with thickness of 1.2/1.5/2.0 mm deviate from DIN 988. The 15 x 22 washers and the washers from 100 x 125 onwards are not covered by DIN 988. The same applies to shim washers with thickness of 0,15 and 0,25 mm.
Diameter tolerances:
| Nominal diameter range |
Outer Diameter D (ISO-Tolerance d12) |
Inner Diameter d (ISO-Tolerance d12) |
| 3 to 6 mm | -0,030 -0,150 |
+0,150 -0,030 |
| over 6 to 10 mm | -0,040 -0,190 |
+0,190 +0,040 |
| over 10 to 18 mm | -0,050 -0,230 |
+0,230 +0,050 |
| over 18 to 30 mm | -0,065 -0,275 |
+0,275 +0,065 |
| over 30 to 50 mm | -0,080 -0,330 |
+0,330 +0,080 |
| over 50 to 80 mm | -0,100 -0,400 |
+0,400 +0,100 |
| over 80 to 120 mm | -0,120 -0,470 |
+0,470 +0,120 |
| over 120 to 180 mm | -0,145 -0,545 |
+0,545 +0,145 |
| over 180 to 250 mm | -0,170 -0,630 |
+0,630 +0,170 |
